c) Mounting the door This appliance has been designed to be built into the kitchen furniture. The recess should have the dimensions shown in picture A.
120 160
Fix the hinges to the machine by means of the M5x8 screws (3-Fig. B). The hinges can be adjusted to compensate for possible uneven thickness of the door. To align the door perfectly it is necessary to loosen the screw (3-Fig. B), adjust the door and tighten the screw again. d) Counter-magnet (6)
5
15
59
195
6
6
00 min.
416 B C
818
416 176,5
5 8
41
165
90 490
820 min
The appliance is preA
6
P0965
Preparation and assembly of the door
The machine is originally pre-arranged for the assembly of a door opening from right to left. In this case it is sufficient to screw in the hinges (1)
6 4
4
arranged for a magnetic closure of the door. To enable a correct operation of this device, it is neces-
and the counter-magnet (6) provided with the appliance, at the right level (Fig. B).
sary to screw the countermagnet (6) (steel disk + rubber ring) into the inner 8 D side of the door. P0984 Its position must correspond to the magnet (4) on the appliance (see picture D).
E
4 6
1 1
2
7 3
5
If the door has to be opened from left to right, invert the position of the plates (7), the magnet (4) and the rubber cap (5)
23
P0982
8
B
5
7
1
(Fig. B and E). Mount the
8
a) Door The dimensions of the door should be: - width 595-598 mm - thickness 16-22 mm The height (C-Fig. C) depends on the height of the adjacent furniture's base. b) Hinges
35 � 14 depth 16-2 2
3
P1014
2
countermagnet (6) and the hinges (1) as previously described.
Important: the plastic screw (8) should never be loosened (Fig. B and E).
To mount the hinges it is necessary to drill two holes (dia. 35 mm, depth 14 mm) on the inner side of the door. The distance between the holes must be 416 mm.
22+1,5
The distance (B) from upper edge of the door to the centre of the hole depends on the adjacent furniture's dimensions.
C
P0422
59
5-598
The required dimensions are given in the picture C. The hinges will be fixed to the door by means of screws for wood (2-Fig. B).
